Smart Meters’ Switching Mode Power Supply = Dirty Electricity

RF radiation is associated with health effects and risks, but there is one more concern with smart meters…dirty electricity.

In this presentation using powerpoint slides to illustrate his talk, Rob States, Consulting Engineer from Corte Madera, CA, explains how smart meters use a switching mode power supply that causes sharp spikes of high voltage on the wiring of the homes they are on and those located nearby.  The power-born spikes Mr. States measured in a home with a smart meter are up to 70,000 volts a second and create “dirty electricity”, which can be associated with health effects. States says that if environmental testing had been done on smart meters before they were placed on virtually every home in California, the problem could have been discovered and prevented. Now, there is no easy solution, except to remove all the smart meters.

Stetzer filters do not adequately address these, according to Mr. States, as the dirty electricity results in low frequency emissions not attenuated (reduced) by the filters. Solid state non-wireless meters also may utilize a switching mode power supply, which would still produce the “dirty electricity”. According to Dr. Sam Milham, dirty electricity is associated with depression, suicides, cardiovascular disease, leukemia, and more…

SMART METER SPECIAL – ROB STATES M.S. AND DR BILL DEAGLE MD – DIRTY ELECTRICITY FROM SWITCHING MODE POWER SUPPLIES AND RF RADIATION ELECTROSMOG AND ELECTROTOXINS … THE FACTS !

http://www.nutrimedical.com/news.jhtml?method=view&news.id=3251

More from Rob States:

New Critical Problem with ‘Smart’ Meters: The Switching-Mode Power Supply (SMPS)

article by Ecological Options Network with Rob States

The Dark Side of Smart Meters (a must-watch)

Rob States, M.S., P.E.
Chief Engineer, PC Engineering
415-927-2739 Office
5 Mohawk Avenue, Corte Madera, CA 94925
rstates@mail.com

Comments are closed.

Copyright Center for Electrosmog Prevention 2011-2019